How to remove a Venetian blind for cleaning?
The venetian blinds have movable louvres where it is possible to adjust the amount of sunlight entering a room. The sheets often absorb dust from the air and cleaning residues from other nearby surfaces. Therefore, to clean them it is necessary to remove them from the wall.
This type of blinds are often placed in the kitchen or in the bathroom. so they are more prone to getting dirty. To make sure the blinds are thoroughly cleaned, or to replace them, you should always remove them completely.
Steps for removing venetian blinds
- The first thing you need to do is raising the shutter to its highest height by pulling the cable control, then pulling the cable to one side.
- The grip has to be loose in order to allow some slack and check that the shutters are locked in place.
- What follows is check the top railwhich is the main structure from which the blinds hang. Remove the front plate to reveal the brackets on both sides of the top rail.
- Check supports to determine how they open.
- Find the screws that hold the brackets in place and remove each screw until the bracket falls out.
- If it exists, it withdraws the central supportThe screws that hold it to the wall or window frame can be unscrewed.
- All that remains is stretching of the sheets so that, together with the rest of the blind, they come out completely.
- It is now possible to clean the roller shutter without any problems.
How to remove slats from Venetian blinds
- Place the slats of the open shutters and horizontal for the window sill. Count the number of slats you remove for a perfect fit.
- Look for the button at the bottom of the shutter slats. This button is used to connect the flat parts of the blinds. It is best to work on one side of the blind at a time to avoid losing several slats.
- Slide very carefully the screwdriver under the edge of the button and pull it out.
- Find the end of the cord inside the hole. Release the knot (or a paper clip) and retain control over the cord.
- It works one side at a time, releases the LADDING STRIPS and hold the cable. Remove the required number of slats until the blinds reach the correct length.
- Remove the knot or attach the clip and push the end into the bottom blind. You may need to trim the excess cable.
- Push the button plug again in place.
- Repeat the process for the other sideIf you are not sure about the length of the rope, make sure to adjust the length to match the other length of the rope.
Tips and warnings
Always save venetian blind slats not used in case damaged, broken or bent slats need to be replaced in the future.
Cleaning Venetian blinds
To clean venetian blinds You need essential items such as a hoover with dusting brush, a microfibre cloth and a multi-purpose cleaner. With all this you only need a few minutes and follow the steps mentioned above to leave the blinds impeccable.
What do we need to clean venetian blinds?
Duster, cleaning brush for Venetian blinds, towel or woollen gloves and a hoover.
How to clean Venetian blinds?
For daily cleaning it is sufficient to use a feather duster to remove the most superficial dust. The dusting brush is to be used on the weekly cleaning or when you are in the habit of cleaning. This brush is made to fit snugly between the planks. Its composition is made of soft hair, which will help you to remove dust easily.
How to clean Venetian blinds more thoroughly?
With the cleaning fluid you use, spray the Venetian blind and then wipe with a clean cloth slat by slat. This type of cleaning is recommended for areas such as kitchens, where grease sticks to walls and curtains easily.
Can't get them spotless?
- Pick up the Venetian.
- Immerse it in the bathtub with water and some cleaning fluid.
- Let it soak for as long as you consider appropriate, depending on the degree of soiling.
- Empty the bathtub and rinses in the shower the rest of the soap and dirt.
- Let it drain and hang it upOnce dry, wipe with a cloth.