Roller shutters: When and how to change the cable and mechanism
Do you have roller shutters but the cable and mechanism are not working? In these cases you have two options: buy one new shutter or learn how to change these elements. In this post we are going to show you when and how to change the cable and mechanism of a roller shutter.
Main problems with roller shutters
Like any other type of roller shutters, roller shutters usually have a series of common problems.
Jammed shutter
It can be caused by various causesThe most common cases are: a broken slat, a box that has become stuck or a loose strap. In these cases, the best thing to do is to analyse the entire roller shutter's travel.
To do this, you must open the drawer of the device and check if there are any broken sheets Once located, all you have to do is push it back to its initial position.
It lowers itself
The reason for this problem is that the dustpan does not perform its function properlyi.e. it does not hold the belt properly. To fix it, you have to remove the wall-mounted dustpan, in the case of folding models you have to open it.
At this point you should check whether the tape that passes through a slit in the dustpan has something that hinders itIf this is the case, you can try to rectify this mistake and make this small tab stick to the area where the tape passes through.
However, you must be very careful not to close it all the way so that the tape has enough space to move around.
Breakage of slats
This tends to happen in areas where it hails quite frequently. In this case, sorry to say, there is no other option than to replace damaged sheets for new ones in perfect condition.
Breakage of the roller shutter motor
The engines are responsible for providing a more comfort in the home; In addition, these products tend to last longer than conventional products. The problem is that they can also fail and cables and mechanisms may need to be adjusted.
In addition, it is very common for you to have to reprogramming the controller which is used to start the motor or the limit switches that mark the shutter travel.
Solutions to these problems
In addition to these problems, there are often other which also needs to be commented on:
- Broken or broken cableThe solution is to replace it and remove the damaged element.
- Cable entangled in the blind tubeAccess the shutter register and lower it little by little, manually, while untangling the cable.
- Cable entangled in the crank mechanismPull out the mechanism and see if the cable is tangled inside it. If so, turn the handle in both directions until it is ready.
- Crank mechanism in bad conditionusually occurs because the screws in the middle have been removed, these should never be removed. The best solution in these cases is to replace the mechanism with a new one.
Repairing a roller shutter, step by step
These are the steps you must follow to repair a roller shutter.
- Dismantle the blind and analyse what the possible problem is.
- Replace the broken partIf a film is defective, it is best to replace it with a new one.
- Put on a new ribbonClean all the sheets and replace the fastening system as a precaution, as it may have been damaged or dirty.
- Change the belt catcherThe roller shutter is, together with the ribbon, two of the elements that suffer the most from roller shutters.
As you can see, changing the cable and mechanism of a roller shutter is a very simple task. fairly straightforwardDo you dare to do it?